ESAB Oxweld 1502 Cutting Nozzle 20 inch - Acetylene

ESAB Oxweld 1502 Cutting Nozzle 20 inch - Acetylene - 13A98

General Purpose. Medium Preheat, sufficient preheat for cutting dirty plate and for beveling.

1502 Series not recommended for acetylene pressure less than 5 psig. ***Sizes 16, 18, 20 recommended for use only with C-37 and C-39 torch.

Hard drawn, electrolytic, tough pitch copper used in one-piece nozzles – withstands heat and wear – outlasts any copper alloy nozzle
One-piece nozzle has triple swaged interior – gas passages are mirror smooth with internal angles rounded for non-turbulent, more efficient gas flow – clean, smooth cuts with minimal kerf
Preheat ports are closely spaced around cutting orifice for greater concentration of preheat flames
Long, parallel preheat passages – permit re-dressing nozzle without affecting performance
One-piece nozzle is a single piece of solid copper – provides maximum cooling – recommended always for acetylene, and for other fuel gases when heat exposure is unusually severe
Two-piece nozzles – recommended for high efficiency with fuel gases other than acetylene – solid copper, heavy-wall external sleeve and brass internal sections can be ordered separately to minimize replacement cost
Conical seats – instant aligning provides tight seal, prevents leaks around nozzle nut

Metal Thickness

1/4-20 in., 6-500 mm

Nozzle Size

1/4-20 in.

No. Preheat Holes or Slots

Cleaning Preheat

54-69

Drill Size Cutting

8-68

Gas Pressure

Cutting Oxygen

20-75 PSIG

Preheat Oxygen

20-60 PSIG

Cutting Acetylene

5-13 PSIG

Cutting Speed

2-25 ipm

Gas Consumption

Total Oxygen

35-1900 CFH

Acetylene

6-90 CFH

Average Kerf Width

.045-.360 in.

Categories