ESAB Oxweld 1507 Nozzle #25 - Acetylene

ESAB Oxweld 1507 Nozzle #25 - Acetylene - 15Z37

Unsurpassed for washing off rivet heads and then piercing rivet to facilitate removal. Each nozzle is equipped with a spud which produces a low-velocity oxygen-stream.

Spudded for max. useful oxygen flow at 50-60 psi.

Hard drawn, electrolytic, tough pitch copper used in one-piece nozzles – withstands heat and wear – outlasts any copper alloy nozzle
One-piece nozzle has triple swaged interior – gas passages are mirror smooth with internal angles rounded for non-turbulent, more efficient gas flow – clean, smooth cuts with minimal kerf
Preheat ports are closely spaced around cutting orifice for greater concentration of preheat flames
Long, parallel preheat passages – permit re-dressing nozzle without affecting performance
One-piece nozzle is a single piece of solid copper – provides maximum cooling – recommended always for acetylene, and for other fuel gases when heat exposure is unusually severe
Two-piece nozzles – recommended for high efficiency with fuel gases other than acetylene – solid copper, heavy-wall external sleeve and brass internal sections can be ordered separately to minimize replacement cost
Conical seats – instant aligning provides tight seal, prevents leaks around nozzle nut

Nozzle Size

19-25

No. Preheat Holes or Slots

Gas Pressure

Cutting Oxygen

50 to 90 PSIG

Cutting Acetylene

5 to 10 PSIG

Categories