ESAB Oxweld 1511 Nozzle #25 - Acetylene

ESAB Oxweld 1511 Nozzle #25 - Acetylene - 15X16

Acetylene nozzle for gouging, grooving plate edges for welding, removing defects from castings, pad washing. Bent 20 degrees. 1511 nozzles have wear stellite skids.

Hard drawn, electrolytic, tough pitch copper used in one-piece nozzles – withstands heat and wear – outlasts any copper alloy nozzle
One-piece nozzle has triple swaged interior – gas passages are mirror smooth with internal angles rounded for non-turbulent, more efficient gas flow – clean, smooth cuts with minimal kerf
Preheat ports are closely spaced around cutting orifice for greater concentration of preheat flames
Long, parallel preheat passages – permit re-dressing nozzle without affecting performance
One-piece nozzle is a single piece of solid copper – provides maximum cooling – recommended always for acetylene, and for
other fuel gases when heat exposure is unusually severe
Two-piece nozzles – recommended for high efficiency with fuel gases other than acetylene – solid copper, heavy-wall external
sleeve and brass internal sections can be ordered separately to minimize replacement cost
Conical seats – instant aligning provides tight seal, prevents leaks around nozzle nut

Specifications:

Nozzle Size	13-25
Gas Pressure
Cutting Oxygen	65 -100 PSIG
Cutting Acetylene	5 -10 PSIG
Gas Consumption
Total Oxygen	160-390 CFH
Acetylene	35-80 CFH
Approx. Speed	1.0-2.8
Approximate Gauge Dimensions
Width	5/16-1/2 in.
Depth	1/8 to 7/16 in.

Categories